Site work and paving for a mixed-use development in Liberty, Missouri. Completed plans call for site work for a road / highway; for paving for a road / highway; sidewalk / parking lot; and sidewalk / parking lot.

All questions, requests for information or clarification pertaining to this bid must be submitted in writing to Jason Breit at jason.breit@lps53.org The District reserves the right to accept or reject all or any part of any quote/proposal/bid, to waive technicalities, and to accept the offer that the District considers to be the most advantageous. The purpose of this ITB is to establish an agreement for the removal and replacement of asphalt and concrete material in parking lots, driveways, sidewalks, etc. at various District buildings described herein. It is the intent of the District to award a service contract to a single vendor. The intent of this ITB is to assure that asphalt and concrete district wide is maintained on an annual basis for all of our facilities to ensure a proper and safe environment for students and staff. The physical state and reliable function of asphalt is one of primary concern to the Liberty Public School District. Seal Coating: - Seal coat application shall consist of the first coat by squeegee applicator and second coat shall be sprayed on. - Seal coat shall be Mac-Problend Slurry or equivalent. Seal coats must contain a minimum of 1 1/2 percent of hot blended rubberized latex additives. - Oil spots must be primed or cleaned to ensure no bleed through occurs after sealing. Crack Sealant: - Hot Pour crack fill should be Crafco-Pls or equivalent (certification is required prior to start of job) - All cracks prior to filling must be blown out with an air compressor to ensure it is free of debris. - If the temperature falls below 380 degrees F the owner will require all pouring to cease until the temperature has risen above 380 degrees F. (Do not exceed 410 degrees F. Asphalt Patching: - Neatly Saw cut OR mill each patch, excavate to stated depth and haul all debris off site. - Tack Coat all areas to achieve a firm bond between new and old asphalt. - Install bituminous surface course asphalt to within 1 1/2 " of finish grade on areas with a depth greater than 2" and compact thoroughly with roller