Renovation of a retail development in Saint Charles, Missouri. Completed plans call for the renovation of a retail development.

Construction/Mechanic Shop Door Replacement. Site Address: 2360 Hwy. D Pre-Qualification: Yes Description: Scope of Work Construction & Mechanic Shop Garage Door Replacement The Contractor shall provide labor & materials to complete the following: 1. Remove (5) 12'x10'1" and (1) 16'x10'1" doors and all hardware associated with them. Then to be properly disposed of, off site. 2. Supply and install (5) manual open 12' x 10' 1", brown in color insulated sectional doors, brown in color insulated sectional doors. o Standard lift, minimum of 24-gauge steel exterior, brown in color. o 14ga hinges and 16ga 2" track (15-degree radius) with continuous jamb angle. o 18-gauge center stile and ends. o Case hardened steel tire rollers, 10 ball bearing, on long solid shaft. o Horizontal track to be reinforced with 13-gauge angle according to size and weight. o Install track stop spring bumpers on all manual open doors. o Install vinyl weather strip on all doors. o Install centered locking hardware with dual locking bars. 3. Supply and install (1) 16' x 10' 1", with windows, Minimum of 25-gauge steel exterior, brown in color. o Minimum of 24-gauge steel exterior, brown in color. o Install approved electric opener with push button, keypad, and remote function. (see section below) o 14ga hinges and 14ga 2" track with continuous jamb angle. o 18-gauge center stile and ends. o Case hardened steel tire rollers, 10 ball bearing, on long solid shaft. o Horizontal track to be reinforced with 13-gauge angle according to size and weight. o Install vinyl weather strip on all doors. o Install centered locking hardware with dual locking bars. o The Garage Doors shall match the existing brown color specified by MDC o The Garage Doors shall be sandwich insulated to a R- value* no less than r14. 4. Supply and install (1) Liftmaster MT Series Logic Trolley garage door operator or approved equivalent. o The operator to be a minimum of 1/2 HP, 115V single-phase motor with instant reverse, capacitor start and overload protection. o Supply and install (1) 3-button station, for open/close/stop functions. o Provide at least (4) dip-switch remote transmitters.