Renovation of a municipal facility in Saint Charles, Missouri. Completed plans call for the renovation of a municipal facility.

Question Deadline 11/06/2024 at 2:00 PM CT Any questions or clarifications concerning this Request for Bid must be submitted in writing via E-mail (preferred), mail or fax to: Donna Clayton Finance Department, St. Charles County Government 201 North Second St St. Charles, Missouri 63301 Fax: (636)949-7589 Dclayton@sccmo.org For questions or inquiries concerning the specifications please contact: Brian Cox, Project Manager Facilities Management Department, St Charles County Government 300 North Second St, Room 101 St. Charles, Missouri 63301 bcox@sccmo.org SCOPE OF WORK: Base Bid for Dimensional asphalt shingle, approximately 4,400 square feet Acceptable Products: CertainTeed Landmark, Tamko Heritage & GAF Timberline 1. Remove all existing asphalt shingle roofing and underlayment down to the wood substrate, haul away and dispose of in accordance to local ordinances. 2. Inspect the existing structural substrate for damages and replace with same materials if panels are found to be dangerous and/or structurally unsound. This includes fascia boards. 3. Furnish and install new ice & water membrane at eaves and protrusions. Peel & Stick membrane must be adhered to wood substrate and extend a minimum 3' up the slope beyond the exterior wall. 4. Furnish and install new #15 organic felt underlayment. Two ply felt application required on all slopes less than 4/12. 5. Furnish and install new drip edge fabricated from .024 aluminum. 6. Furnish and install new gutters & downspouts profile to match existing. 7. Furnish and install new dimensional fiberglass shingle, color to be selected by owner, meeting: Applicable Standards o ASTM D 3018, Type I o ASTM D228 o ASTM D 3462 o ASTM E 108 Fire Resistance: Class A o ASTM D 3181 Class H Wind Resistance o ASTM D 7158 Class H Wind Resistance o UL 2390/ASTM D6381 Class H Wind Resistance o UL 790 Fire Resistance: Class A o UL 997 Wind Resistance SHEET METAL: o Gutter & Downspouts to be fabricated from .032 Kynar coated aluminum. Color to be selected by owner o Fascia cap fabricated from .024 Kynar coated steel gauge and be ES1 rated. o All sheet metal design, fabrication and installation to be performed by a qualified sheet metal contractor who employees fully insured journeyman "sheet metal workers" with extensive experience in the design and installation of commercial/industrial systems. o All sheet metal fabrication and work to be performed in accordance with the SMACNA sheet metal manuals, manufacturer's specifications, local building codes (sheet metal, drainage and plumbing), whichever is more stringent. *The list of planholders and/or interested bidders is not being tracked by the stakeholders involved with this project. If you are an interested contractor and wish to be listed as a bidder, please notify our editorial staff at addtobidlist@constructconnect.com.