Site work and paving for a mixed-use development in Plattsmouth, Nebraska. Completed plans call for site work for a sidewalk / parking lot; for paving for a sidewalk / parking lot; and water / sewer project.

Plattsmouth Water Supply Contract W3 - Water Transmission Main, Contract 2-2025 Description: Project includes 8-miles of 20-inch water transmission main from MUD Platte South WTP to the City of Plattsmouth. Project includes removal and replacement of Avenue B from N 23rd Street to N 16th Street. The approximate quantities are 40,000 LF of trenched 8-inch to 20-inch water main, 750 LF of trenchless with 16-inch to 30-inch steel casing, 10,000 LF of 16-inch to 20-inch trenchless (no casing), 2,000 CY of excavation, 4,900 LF of subdrain and storm sewer, 46 water and sanitary service connections, 2,330 LF of CIPP lining, 10,600 SY of aggregate base, 8,600 SY of PCC mainline paving, 1,500 SY of PCC driveways, 1,900 SY of PCC Sidewalk, 48 acres of seeding, erosion control, traffic control, and other associated work. Milestone 1 requires installation of all water transmission main within agricultural areas (row crops) shall be installed and disturbed surfaces restored by April 1, 2026. Milestone 2 shall require the water transmission main to be installed, tested, and fully operational by July 1, 2026. The Work will be substantially complete on or before December 20, 2026, and will be completed and ready for final payment in accordance with Paragraph 15.06 of the General Conditions on or before June 1, 2027. Work under the proposed Project Contract shall be commenced within fifteen (15) calendar days from the date of Notice to Proceed. The "Notice to Proceed" is anticipated to be issued within ten (10) days of the Effective Date of the Agreement. The Contractor's bid bond, certified check, or cashier's check shall be in an amount of 5% of the Contractor's bid amount made payable to the Treasurer of the City of Plattsmouth, Nebraska. The certified or cashier's check may be cashed by the Owner, or the bid bond forfeited to the Owner as liquidated damages in the event the successful bidder fails to enter into a Contract and file an acceptable bond satisfactory to the Owner assuring the faithful fulfillment of the Contract and maintenance of said improvements, as required by law, within ten days after the acceptance of the Contractor's bid. No Bidder shall withdraw his Bid for at least 30 days after the actual date of the receipt of bids. Contractor shall comply with Federal procurement standards set forth in the bidding documents to the extent that such standards apply to the work, and are required for the costs of such work to be eligible for FEMA reimbursement. To the extent applicable, Contractor shall ensure that each of its subcontractors includes certain provisions and that each sub-contractors complete with the requirements set forth in each provision. Contractor and subcontractors shall provide evidence of System for Award Management (SAM) registration. DAVIS BACON ACT WAGE DETERMINATIONS: Contractors and subcontractors on USEPA federally assisted construction projects are required to pay their laborers and mechanics wages not less than those established by the U.S. Department of Labor. A current wage decision containing the appropriate building and/or heavy type rates is included in the specifications for bidding purposes. DEBARMENT AND SUSPENSION: The prospective participants must certify by submittal of EPA Form 5700-49, Certification Regarding Debarment, Suspension and Other Responsibility Matters, that to the best of its knowledge and belief that it and its principals are not presently debarred, suspended, proposed for debarment, declared ineligible, or voluntarily excluded from covered transactions by any federal department or agency. NONDISCRIMINATION IN EMPLOYMENT: Bidders on this work will be required to comply with the President's Executive Order No. 11246. Requirements for bidders and contractors under this order are explained in the specifications. DISADVANTAGED BUSINESS ENTERPRISE (DBE): Each bidder must fully comply with the requirements, terms and conditions of the U.S. Environmental Protection Agency, Disadvantaged Business Enterprise (DBE) requirements, including the fair share objectives for disadvantaged business participation during the performance of this contract. The bidder commits itself to the fair share objective for disadvantaged business participation contained herein and all other requirements, terms and conditions of these bid conditions by submitting a properly signed bid. AMERICAN IRON AND STEEL PRODUCTS: On January 17, 2014, H.R. 3547, "Consolidated Appropriations Act, 2014," was enacted. Section 436 of the Act requires that none of the appropriated funds may be used for the construction, alteration, maintenance, or repair of a public water system or treatment works unless all of the iron and steel products used in the project are produced in the United States, unless a waiver is provided to the recipient by EPA. Conditions for the waiver are found under the Information for Bidders. The term "iron and steel products" means the following products made primarily of iron or steel: lined or unlined pipes and fittings, manhole covers and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel, reinforced precast concrete, and construction materials. The Owner reserves the right to reject any and all bids, to waive irregularities and informalities therein and to award the Contract in the best interest of the Owner. Question Deadline Feb 27, 2025 Document notes Prospective Bidders may examine the Bidding Documents at the Issuing Office on Mondays through Fridays between the hours of 8 a.m. to noon and 1 p.m. to 5 p.m., and may obtain copies of the Bidding Documents from the Issuing Office as described below.