Renovation of a mixed-use development in Omaha, Nebraska. Completed plans call for the renovation of a educational facility.

OPS Blackburn VAVs & HVAC Control Replacement Questions submitted in any other form, including by hard copy, facsimile and telephone, and questions submitted to an email address other than the one indicated in these Bid Documents will NOT be answered Any questions or requests for interpretation of these Bid Documents must be submitted in writing by e-mail to the question submission box at the email address included on the Cover Page of the Bid Documents, by 2:00 p.m. CT on or before the deadline for submission of questions. The subject line of the email must include at a minimum the Bid Name and Bid Number of the Project. Both the question submission box address and the deadline are listed on the Cover Page The work covered under this Section of the Specifications is intended to include the furnishing of all equipment, materials and labor or reasonably incidental to the complete operating installation of systems as shown on the plan and of related equipment all as indicated on the drawings, as hereinbefore specified under Division 22 and as hereinafter specified in this Section. B. Section Includes: 1. Balancing Air Systems: a. Constant-volume air systems. b. Variable-air-volume systems. 2. Balancing Hydronic Piping Systems: a. Constant-flow hydronic systems. b. Variable-flow hydronic systems. In general, all materials and equipment to be furnished by Contractor must be of good quality, new and unused, undamaged, and shall be constructed and installed as required in the Contract Documents and of the types of equipment and materials as specified. The Work called for in these Bid Documents includes the design, furnishing and installation of the VAVs & HVAC Control Replacement at Blackburn Alternative Program Facility, located at 2606 Hamilton St, Omaha, NE 68131. The Work includes, but is not limited to all mechanical, electric, control, low voltage wiring, pathways, testing and balancing, pressure sensors, calibrating all new terminal units, electrical modifications and related Work described more fully in the Project Drawings and the Project Specifications.