Renovation of a mixed-use development in Chapmanville, West Virginia. Completed plans call for the renovation of a conference / convention center.

The West Virginia Purchasing Division is soliciting bids on behalf of the West Virginia Division of Natural Resources to establish a contract for the replacement of the HVAC system at the Chief Logan State Park Lodge and Conference Center located near Logan, WV. The work involves heating and cooling and air conditioning HVAC construction as per the attached specifications and terms and conditions. This sequence provides the roadmap to the BAS for this project. There may be requirements in the plans and specifications which are not in this sequence, they will be in full effect for the project. Where they may conflict, the Engineer will be the sole authority of interpretation and discrepancy resolution. Provide one, stand-alone, networked, building automation and control system for the project. The control system is to be a microprocessor based system utilizing DDC control and electric actuation. The system will include an on-site building Owner interface through a new desktop computer (provide new licensed desktop software as required). The desktop will have the minimum system and storage capacity to store and display 50 selectable data point trends on 1 minute intervals for one year. Additionally, full operability Web (internet) interface will permit the Owner to read and acknowledge alarms, adjust the occupancy schedule, set points, trend data, review overall system status, all remotely. Carrier IVu is the basis of design. The IVu Internet interface will permit monitoring and control from the central location over a secure Internet connection and is to be included in the building BAS system. All programming, devices, wiring, etc., required to access the BAS system through the web interface is included in this project. The system will keep a login record file and log each change made to the system under the ID from which the change was made. THIS PROJECT REQUIRES BOTH SCOPE AND TIMING SELECTIVE DEMOLITION. Demolition of all existing systems, equipment, and components shall be coordinated with all the other trades involved with the project. The responsibility for all demolition coordination, scope, and timing lies ultimately with the prime contractor, but also lies with each trade involved. All systems, components, and equipment indicated by shaded areas on the project drawings will be demolished unless they are to be re-used. The timing of demolition of any systems or equipment much be in such a manner that permits continued building operations during construction. Any system or equipment demolished in a manner that disallows for continued operations during construction will be reinstalled (or an Engineer-accepted temporary solution will be installed) by the contractor at no additional cost to the Owner. No system shall be taken out of service without the approval of the Owner