Renovation and addition to an educational facility in Shakopee, Minnesota. Completed plans call for the addition of a 5,000-square-foot educational facility; and for the renovation of a 11,000-square-foot educational facility.

additional project contact information is specified in section 00 01 03 - project directory. e. the project consists of an addition of approximately 5,000 sf and renovations of approximately 11,000 sf.. 1. briefly and without force and effect upon the contract documents, the work of this single prime contract can be summarized as follows: 2. work under this contract includes: a. sitework: 1) site utilities: water mains, storm sewers, sanitary sewers. 2) rough and finish grading, paving, concrete sidewalks and plazas, ground cover, trees and shrubs. 3) fencing and miscellaneous site improvements. b. building structure: 1) concrete footings, concrete slabs on grade, steel framing, precast concrete plank/concrete topping floor systems, and precast concrete plank/tees roof systems, insulated steel stud exterior bearing wall systems, and miscellaneous metal items including stairs, railings. c. building enclosure: 1) exterior wall systems of face brick, decorative concrete masonry units, cavity wall insulation, metal panels. 2) aluminum windows, curtainwall, storefront entrance systems and glazing. galvanized hollow metal doors and frames. storm louvers and storm windows. 3) roofing systems of patching ballasted single ply and new built-up, pre-finished metal coping. d. interior finishes: 1) insulated gypsum board/metal stud partitions. 2) floor finishes of carpet, lvt, porcelain tile, quarry tile, and sealed concrete. 3) wall finishes of paint, vinyl wallcovering, ceramic tile, porcelain tile. 4) ceiling finishes of acoustical lay-in tile, gypsum board, gypsum board soffits, wood slat ceiling system. 5) plastic laminate casework, hm doors and frames, wood doors, access panels, hardware, glazing, acoustic treatment, food service equipment, toilet accessories, markerboards, tackboards, display cases, signage, miscellaneous specialties. e. mechanical systems: 1) plumbing including, supply and waste piping systems, piping insulation, plumbing fixtures. 2) ventilation to include, air handlers, ductwork, duct insulation, dx condensers. 3) temperature control system. f. electrical systems: 1) electrical service, switchgear, distribution panels, conduit and wiring. 2) interior and exterior lighting. parking lot lighting. 3) low voltage work to include: a/v systems, data room relocations.. 4) fire alarm. f. keep architect fully informed about progress of the work, performance of the work and potential problems