Site work for a fire / police facility in Binghamton, New York. Completed plans call for site work for a fire / police facility.

Reference Number 0000415186 Services to be provded: Temporary Tank Systems Tank 141 and Tank 142 Removal New Tank Installation to Replace Tank 141 (New Tank ID number TBD) New Tank Installation to Replace Tank 142 (New Tank ID number TBD) Fuel Dispenser System Removal and Replacement Remote Fill Boxes Removal and Replacement Replace Existing Veeder-Root TLS-300 Control System with new Veeder-Root TLS-450 Plus Control System Purchase Type Duration: NTP plus 45 days Question Deadline 03/23/2026 at 4:00 PM ET Questions are submitted online No . Direct all technical questions to: Ramboll Scott Mosher (585) 944-7614 Scott.Mosher@ramboll.com Direct all administrative questions to: Broome County DPW, Engineering Division Chenoa C.F. Hailey, EIII (607) 778-2470 Chenoa.Hailey@broomecountyny.gov Bonding Requirements - Bid Bond 5 % - Performance Bond 100 % - Labor and Materials Bond 100 % - Payment Bond 100 % Each Proposal must be accompanied by a Deposit of Cash, Certified Check or Bid Bond, payable to Broome County Director of OMB, in the amount specified by this advertisement. The retention and disposal of such Page 2 of 244 Cash, Certified Check or Bid Bond, by the County, shall conform to Article 5A, Section 105 of the General Municipal Law, as amended. Minimum Wage Rates shall be as determined by the New York State Department of Labor. If the bid price for this project exceeds $100,000, then the Broome County Minority Business Enterprise (MBE) subcontracting goal is 3.5%, and the EEO Minority Hiring Goal is 5.0% in accordance with the programs detailed in the bid documents. The Broome County Board of Acquisition and Contracts (BAC) reserves the right to reject any and all Bids offered. Services to be Provided - Temporary Tank Systems o Provide necessary labor and equipment required to install temporary tank systems equipped with fuel dispensers for facility use until new tanks are commissioned. o Tanks should be sized as follows: - (1) 1,000-gallons on-road diesel -(1) 500-gallons gasoline o Tanks should be provided with secondary containment (i.e., double-walled or situated within diking and other equipment for overfill protection) and an overfill prevention device (e.g., fuel level gauge, high-level alarm) o Location of tanks should be coordinated with the owner. o Fuel for tank systems will be provided by Broome County. - Tank 141 and Tank 142 Removal: o Price to include labor, materials, and equipment to remove Tank 141 and Tank 142. - Provide all necessary regulatory closure documentation of tank systems to agencies and Broome County. - Disconnection of and removal of aboveground conduit and wiring from stub-ups to tanks. - Removal of tank, appurtenances, concrete shell and sludge for off-site disposal in accordance with regulations. - Contractor to draw down fuel tanks to lowest point prior to removal. - New Tank Installation to Replace Tank 141 (New Tank ID number TBD) o Provide necessary labor and equipment to complete the following: - Provide and install new Highland double-walled Fireguard 4,000-gallon tank - Tank and installation shall meet all current code and regulatory requirements. - Contractor to complete/submit all applicable NYSDEC notices/applications. - Provide fixed ladder and gangway to access top of tank. - Provide and install all necessary pumps, piping, aboveground wiring/conduit and appurtenances for a complete and operational tank systems. - New Tank Installation to Replace Tank 142 (New Tank ID number TBD) o Provide necessary labor and equipment to complete the following: - Provide and install new Highland double-walled Fireguard 6,000-gallon tank. - Tank and installation shall meet all current code and regulatory requirements. - Contractor to complete/submit all applicable NYSDEC notices/applications. -Provide fixed ladder and gangway to access top of tank. - Provide and install all necessary pumps, piping, aboveground wiring/conduit and appurtenances for a complete and operational tank system. - Fuel Dispenser System Removal and Replacement o Provide necessary labor and equipment required to replace two existing fuel dispensers in-kind. - Disconnect existing fuel dispensers from dispenser sump. - Provide and install new Gas Boy mechanical dispensers in accordance with manufacturer's instructions, and current code and regulatory requirements. -Commission new dispenser systems. - Coordinate with owner for storage of existing dispenser systems. - Remote Fill Boxes Removal and Replacement o Provide necessary labor and equipment required to replace existing remote fill boxes, fuel piping and appurtenances. - Fill boxes should be stainless steel constructed with a minimum of 15-gallon capacity, equipped with a hinged locking door, stainless steel ball valve, and internal hand pump. - Remote Fill Box installation shall meet all current code and regulatory requirements. - Dispose of existing remote fill boxes off-site in accordance with applicable regulations. - Replace Existing Veeder-Root TLS-300 Control System with new Veeder-Root TLS-450 Plus Control System. o Provide necessary labor and equipment to complete the following: - Replace console, system wiring and aboveground conduit at tanks, utilizing existing conduits. - Provide new probes and sensors for each tank system. - Commission system to allow for remote monitoring.