Renovation of a pipeline in San Luis Obispo, California. Completed plans call for the renovation of a pipeline.

The deadline to submit questions is 9:00 a.m. on Friday, July 10, 2026. Responses to questions received prior to the deadline will be sent as promptly as practical. Replacement of Energy Dissipating Valve Hydraulic Piping The WORK includes replacement of energy dissipating valve (EDV) hydraulic piping and miscellaneous valves. The Central Coast Water Authority reserves the right to reject any and all Bids, to waive any informality in a bid and to make awards to the lowest responsive, responsible Bidder(s) as it may best serve its interest. Question deadline - 06/30/2026 All questions about the meaning or intent of the Contract Documents are to be directed to Chris Wall, Engineering Technician, 255 Industrial Way, Buellton, CA 92427 (Phone 805-688-2292 EXT 235, Fax 805-680-4700, Email ctw@ccwa.com). No oral interpretations will be made to any Bidder as to the meaning of the Contract Documents. Requests for an interpretation shall be made in writing and delivered to the Owner no later than seven (7) days before the time for opening the Bids. Central Coast Water Authority staff will be present to conduct a tour of the site and facilities and answer questions. All communications relative to this Project prior to opening of Bids shall be made in writing to the address, telephone, and email address listed below. Email is the preferred method of communication. Demolish existing carbon steel hydraulic piping and hose assemblies connecting two parallel hydraulic power units (HPU) to two hydraulically operated 24-inch diameter horizontal multi-jet sleeve valves and four hydraulically operated 24-inch trunnion mounted ball valves. The work is in a ground-level Hydraulic equipment building and a confined space vault, with the only access through a hatch to a ladder descending approximately 20'. The vault is the location where most of the installation work will take place. 1. All hydraulic supply and return tubing, hoses, fittings, and valves shall be removed and replaced. 2. Replace the demolished piping with Type 316 stainless steel seamless hydraulic tube and compression fittings. 3. Reuse the existing strut hanger and floor-mounted strut framing. 4. Fill the new piping system with oil prefiltered to 10 microns and flush until the sampled oil test results are within the ISO standard limits specified in section 40 22 15. 5. Perform a hydrostatic test at 3,000 psi. 6. Miscellaneous work and clean-up.