Demolition, site work, paving and renovation of a mixed-use development in New Brighton, Minnesota. Completed plans call for site work for a sidewalk / parking lot; for paving for a sidewalk / parking lot; water / sewer project; for the renovation of a water / sewer project; and for the demolition of a sidewalk / parking lot.

Bidder shall submit all questions about the meaning or intent of the Bidding Documents to Engineer in writing to the Issuing Office. Contact information and submittal procedures for such questions are as follows: 7533 Sunwood Drive NW, Suite 206, Ramsey, MN 55303, (763) 433-2851, fax (763)427-0833 - Question Deadline 07/01/2025 GENERAL A. The WORK to be performed under this Contract shall consist of furnishing all plant, tools, equipment, materials, supplies, and manufactured articles and for furnishing all transportation and services, including fuel, power, water, and essential communications, and for the performance of all labor, work, or other operations required for the fulfillment of the Contract in strict accordance with the Contract Documents. The WORK shall be complete, and all work, materials, and services not expressly shown or called for in the Contract Documents which may be necessary for the complete and proper construction of the WORK in good faith shall be performed, furnished, and installed by the CONTRACTOR as though originally so specified or shown, at no increase in cost to the OWNER. 1.2 PROJECT LOCATION A. The project is located in the City of New Brighton which is located in Ramsey County. The project location is shown on the vicinity map in the design drawing set. 1.3 PROJECT DESCRIPTION A. The work hereafter referred to requires the complete construction and start-up necessary for the facility with all required necessary equipment, generally described, but not limited to, in the following paragraphs: 1. Installation of new prepackaged fiberglass lift station with grinder pumps, concrete lid and bituminous driveway. 2. Install new forcemain through existing forcemain 3. Demolition of existing lift station. 4. Connection to control panel.