Renovation of an educational facility in Concord, California. Completed plans call for the renovation of a educational facility.

2025 MDUSD Dent Center Technology Infrastructure Upgrade The Project consists of interior painting of common spaces and corridors. To bid on this Project, the Bidder is required to possess one or more of the following State of California Contractor Licenses: B and/or C-10. The Bidder's license(s) must be active and in good standing at the time of the bid opening and must remain so throughout the term of the Contract. Question Deadline 07/29/2025 at 3:00 PM PT All questions about the meaning or intent of the Contract Documents are to be directed in writing to the District representative, Mike Torres via email at mike.torres@6dpmcm.com. SCOPE A. The work will include but not be limited to the following objectives: 1. Contractor shall furnish and install all required components and accessories as outlined in the design documents for a complete and operable turn-key system. 2. Quality workmanship is a high priority for the District and the Contractor shall be held to a high-level of professional workmanship. Contractors unfamiliar with the Districts standards shall familiarize themselves with the standards and requirements prior to beginning work. 3. The Contractor shall furnish and install fire-treated (three quarter inch) plywood for the MDF room (all walls, from floor level to 8 high) and IDF locations (as required or indicated in the design documents). 4. The Contractor shall furnish and install a ground bus bar at the MDF and IDF rooms. 5. The Contractor shall furnish and install all required racks and cabinets. 6. The Contractor shall install owner-provided uninterruptable power supply(ies) (UPS) for the MDF and/or IDF racks. 7. The Contractor shall furnish and install all newly required conduit/raceway. 8. The Contractor shall furnish and install all wire/cable (copper/fiber optic) as required. 9. The Contractor shall terminate all strands of fiber at each fiber enclosure. 10. The Contractor shall furnish and install termination all end-point equipment (patch panels, jacks, wallplates, enclosures, etc.). 11. The Contractor shall furnish and install all patch cords (copper/fiber). 12. The Contractor shall test and certify (for warranty) the installed cable plant