Site work and paving for a road / highway in Cedarburg, Wisconsin. Completed plans call for site work for a road / highway; and for paving for a road / highway.

The Project Consists of the Following Pavement. Work: Placing Micro Surfacing Over Approximately 4,525 Square Yards of Existing Asphalt Pavement on Hamilton Road Between Washington Avenue and the Railroad Tracks. The Micro Surfacing Shall Consist of Issa Type Ii MixtureContaining a Mixture of Polymer modified Emulsified Asphalt, Mineral Aggregate, Water, and Specified Additives, Proportioned, Mixed, and Uniformly Applied at a Rate of 18 to 22 Lbs/sy Spread Over a Properly Prepared Asphalt Surface. Bids Must Be Accompanied by a Bid Bond or Cashier's Check in an Amount Equal to 5% of the Total Bid. The Contractor Selected by the City Must Furnish a Performance Bond and a Payment Bond, in the Amount of 100% of the Bid, to Guarantee Satisfactory Completion of the Work. The City of Cedarburg Reserves the Right to Accept or Reject Any or All Proposals and to Accept the Proposal Deemed Most Advantageous to the City. No Bid Shall Be Withdrawn for a Period of 30 Days After the Opening of the Bids Without Written Consent From the City. DESCRIPTION Transverse Leveling: Slurry Leveling must be applied in areas where recessed joints (dips) in a road caused by deterioration underneath the pavement surface occur. Slurry Leveling will be applied to improve a road's ride and seals large cracks in the surface of the pavement. Contractor must furnish all labor, equipment, material, supplies, signage, traffic control, and other incidentals necessary to provide Transverse Leveling. Material for Transverse Leveling shall consist of a TYPE II mixture, containing CSS-1hlm emulsion, mineral aggregate, water, and specified additives, proportioned, mixed, and uniformly spread over a properly prepared asphalt surface. Micro Surfacing Scratch Course: Scratch Course must be used to pre-level uneven areas, fill minor ruts, and fill minor cracking. Contractor must furnish all labor, equipment, material, supplies, signage, traffic control, and other incidentals necessary to provide Micro Surfacing Scratch Course. Scratch Course shall consist of a TYPE II mixture containing CSS-1hlm emulsion, mineral aggregate, water, and specified additives, proportioned, mixed, and uniformly applied at a rate of 12 to 15 LBS/SY spread over a properly prepared asphalt surface. The completed Scratch Course shall adhere firmly to the prepared surface and have a skid-resistant surface texture. Micro Surfacing Finish Course: Contractor must furnish all labor, equipment, material, supplies, signage, traffic control, and other incidentals necessary to provide Micro Surfacing. Micro Surfacing shall consist of an ISSA TYPE II mixture containing a mixture of polymer-modified emulsified asphalt, mineral aggregate, water, and specified additives, proportioned, mixed, and uniformly applied at a rate of 18 to 22 LBS/SY spread over a properly prepared asphalt surface. The completed Micro Surfacing shall leave a homogeneous mat, adhere firmly to the prepared surface, and have a skid-resistant surface texture throughout its service life. If you have any questions, please contact City Engineer Mike Wieser at (262) 375-7610. All work under this Contract shall be completed on or before October 17, 2025.