Renovation of a military facility in Cheyenne, Wyoming. Completed plans call for the renovation of a military facility.

Remove Existing Unit: - Safely disconnect and remove the existing systems, including all associated components (e.g., duct connections, gas line, electrical wiring, venting). - Properly dispose of the old sytems and all associated waste materials in accordance with environmental regulations. Replace Components: - Install the new furnace according to the manufacturer's specifications and all applicable codes and regulations. The new systems shall be of an equivalent spec (e.g., Natural Gas, furnace with an 80/90 BTU/hr input and a 96% efficiency rating. The make and model are Lennox G61MPV-60C-090-07. - Connect the new natural gas unit to existing gas lines, water lines, electrical (if required) and venting system, ensuring proper fittings and seals. - Connect the systems to the existing ductwork, gas line, electrical connections, and venting system - Ensure all connections are secure and leak-free. - Inspect the existing ductwork for leaks, damage, and proper insulation. - Clean the work area, removing any debris or leftover materials. - Contractor responsible for disposing of old hot water heaters Program new controls on EMCS. - Follow existing programming for new systems install, with same parameters. All Requests For Information Due: 10:00 AM MST, 11 September 2025 Background / Purpose: To improve heating performance and reliability in Building 35 & 40, the existing heating systems will be replaced. The current units are nearing the end of lifespan and have demonstrated numerous functional problems. Additional Description: The new equipment must include the following salient description: o Building 40 Furnace: The new furnace shall be of an equivalent spec (e.g., Natural Gas, furnace with an 80/90 BTU/hr input and a 96% efficiency rating. The make and model are Lennox G61MPV-60C-090-07. o Replacement Instructions: o Site Assessment: - Conduct a site assessment to evaluate the existing furnace, including size, capacity, gas line configuration, ductwork, venting, and available space. - Recommend a replacement unit based on facility needs (e.g., BTU rating, energy efficiency). - Identify any potential challenges or modifications required for installation. - Ensure all repairs comply with local, state, and national fire safety regulations. o Safety Measures: - Implement safety protocols for the repair work, including the use of personal protective equipment (PPE). o Remove Existing Unit: - Safely disconnect and remove the existing furnace, including all associated components (e.g., duct connections, gas line, electrical wiring, venting). - Properly dispose of the old furnace and all associated waste materials in accordance with environmental regulations. o Replace Components: - Install the new furnace according to the manufacturer'specifications and all applicable codes and regulations. The new furnace shall be of an equivalent spec. -Connect the new natural gas unit to existing gas lines, water lines, electrical (if required) and venting system, ensuring proper fittings and seals. - Connect the furnace to the existing ductwork, gas line, electrical connections, and venting system. - Ensure all connections are secure and leak-free. - Inspect the existing ductwork for leaks, damage, and proper insulation. - Clean the work area, removing any debris or leftover materials. - Contractor responsible for disposing of old hot water heaters o Programming: - Program new furnace controls on EMCS. - Follow existing programming for new furnace install, with same parameters All Requests for Information (RFI's) will ONLY be accepted via email and should be sent to benjamin.c.taylor10.mil@army.mil and nickolas.l.woske.civ@army.mil with a Subject: W912L325RA008 RFI. RFI's will not be answered individually but will be compiled and the answers to all will be posted to the SAM.gov posting for this requirement for all to see.