Site work and paving for a transportation facility in Prosser, Washington. Completed plans call for site work for a transportation facility; and for paving for a transportation facility.

The scope of work includes: 1. Repair existing cracks on all runway, taxiway, taxilane, and apron pavement. 2. Apply slurry seal to all runway, taxiway, taxilane, and apron pavement. 3. Restore pavement markings impacted by slurry seal. 4. Replace Runway 8-26 existing medium intensity edge lights (MIRLs) with new LED fixtures and system. 5. Replace all existing taxiway edge reflectors on Taxiway A and the connector taxiways. 6. Replace all existing Runway 8-26 related signage with LED fixtures and system. 7. Replace Runway 8 PAPI (Port owned) with LED fixtures and system. 8. Replace Runway 26 PAPI (Port owned) with LED fixtures and system. 9. Replace Runway 8 REIL (Port owned) with LED fixtures and system. 10. Replace Runway 26 REIL (Port owned) with LED fixtures and system. 11. Replace the lighted primary wind cone with LED fixtures. It is assumed that the segmented circle will not be impacted as a part of this project. 12. Replace the existing nonlighted supplemental wind cone with a lighted LED fixture. 13. Replace and modify the existing electrical room vault, including new regulator, panel board, disconnect switch, radio control unit and associated antenna, and various other components. The replaced and modified components will be LED compatible systems. 14. Demolish existing 'above ground' infrastructure related to the lighting, signage, PAPIs, REILs, wind cones, pavement edge reflectors, and electrical room fixtures to be removed. Technical questions shall be directed to Bryan Condon, Century West Engineering Corporation, bcondon@centurywest.com. All project-specific questions, and requests for clarification, must be submitted in writing, via email, by 12:00 PM on August 20, 2025 to Bryan Condon. If required, an addendum will be prepared and issued no later than August 21, 2025 The Port of Benton, in accordance with the provisions of Title VI of the Civil Rights Act of 1964 (78 Stat. 252, 42 U.S.C. 2000d to 2000d-4) and the Regulations, hereby notifies all bidders that it will affirmatively ensure that any contract entered into pursuant to this advertisement, disadvantaged business enterprises (DBE) will be afforded full and fair opportunity to submit bids in response to this invitation and will not be discriminated against on the grounds of race, color, or national origin in consideration for an award. The Port of Benton is an Equal Opportunity Employer and encourages woman, minority, DBE, and small businesses to participate in the competitive bidding process. Bidders are required to be licensed in accordance with and comply with the "Public Contractor's License Law of the State of Washington. Proposals must be accompanied by cash, cashier's check, certified check, bank money order, bank draft or a bid bond or bonds in the amount of five percent (5%) of the amount of the bid as a guarantee that the successful bidder will enter into the required contract. The Port of Benton reserves the right to reject any and all bids or to accept any bid deemed by them to be in the best interest of the Port pursuant to the terms of the general Conditions. The contract will be awarded to the bidder submitting the lowest, responsive and responsible bid. All bidders are cautioned to be aware of the requirement to have their bids considered responsive. Proposals must be sealed and marked: Sealed Bid for: Port of Benton Prosser Airport Pavement Rehabilitation and Electrical Replacement Project Aip Project #3-53-0050-023- 2023" Bids shall be marked with the Contractor's current License Number and Class and be addressed to the undersigned. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.